With the described technique, two bioabsorbable suture anchors are inserted to create a medial row through the intact cuff for fixation of the fragment of the greater tuberosity. The medial row is repaired with a sliding knot. After confirmation of the fracture site, pilot holes for a PushLock anchor (Arthrex, Naples, FL) are prepared directly in line with the medial anchors and approximately 5 to 10 mm distal to the lateral edge of the fragment of the greater tuberosity. A suture strand from each anchor in the medial row is retrieved. Both suture strands are threaded through the PushLock eyelet on the distal end of the driver. The anchor is advanced completely into the pilot hole. These steps are repeated for a second anchor. If a dog-ear deformity is observed at the margin after complete reduction of the greater tuberosity, a stitch is made by use of a suture hook and one strand of the uncut suture from the lateral row of the joint via the modified suture-bridge technique. Arthroscopic reduction and internal fixation of displaced greater tuberosity fractures with the suture-bridge technique described by us provide adequate fixation with improvement of the pressurized contact area of thefracture and can be used as an additional modality of arthroscopic treatment.

In cases of displaced greater tuberosity fractures, treatments by arthroscopic-assisted reduction and percutaneous screwfixation have been reported. However, in cases in which there is a comminuted fracture or a minimally displaced fracturecombined with concomitant lesions such as rotator cuff tear or labral pathology, it is difficult to reduce the fracture and to treat other pathologies by use of a percutaneous screw. Recently, many surgeons have used the double-row repair method in rotator cuff repair, which provides a tendon-bone interface better suited for biologic healing and restoring normal anatomy. In accordance with this method, we used the arthroscopic technique of double-row suture anchorfixation for a minimally displaced greater tuberosity fracture without additional incision. Initially, debridement was performed on the fracture surface by use of a shaver, and the medial-row anchor was inserted through the anterior portal or the intact cuff. Two lateral-row anchors were inserted just anterior and posterior to the lower margin of the fractured fragment under C-arm guidance. The medial-row sutures and lateral-row sutures were then placed. Arthroscopic double-row suture anchor fixation of a displaced greater tuberosity fracture restores the original footprint of the rotator cuff and normal tendon-bone interface of the displaced greater tuberosity fracture.